Intel SIM4-02 Uživatelský manuál

© Intel Corporation 1972 ® INTEL CORP. 3065 Bowers Avenue, Santa Clara, California 95051 • (408) 246-7501 MICRO COMPUTER SYSTEMS SIM4-02 Hardware S

The bank number in the chart above is the value of the accumulator during a DCl instruction, needed to address that bank of RAMs. The port number give

ASTERISK IS SIMULATOR OUTPUT INITIALIZE ~ ~EADY INDICATION .L. MEMORY BLOCK *Q0 ., 12!j IS ASSIGNED /r .10 01 0:BPP~PNPPPF BPPPPPPPNF 2:BPP~P~PPNF 3

FIRST LINE DUMP RAM COMMAND £ LOCATION 3 1110 1010 = RDR *Z *00 20 2 8 0 1 2 9 14 10 11 0 6 8 2 9 14 11 1 5 0 6 8 11 2 14 1 4 0 0 0 "

01BPPNPNPPPF 41BNPNNPPPPF 81BNPNNPPPPF 121BPPPPPPPPF 9 14 10 0 0 0 0 2 I BPPNPNPPNF 61 BPPNPNPPNF 10 I BPPPPPPPPF 141BPPPPPPPPF Figure 9.3 Miscella

fiH/ 0:START. rIM 4P 0 2: SRC 4P 3: RDR 4ft: XCH 0 5% INC 8 6: SRC 4P 7: RDR 8: XCH I 9: JMS AND II: XCH 2 12: WMP 13: JUN START IS: NOP 16: =104ft 1

CONTENTS Page 1.0 Introduction ... . 2.0 Number Systems ... . 3.0 Desc

SIM4-02 HARDWARE SIMULATOR 1.0 INTRODUCTION The SIM4-02 Hardware Simulator is a program written for the MCS-4 ™ series Micro Computer System. This

A breakpoint register is associated with the simulated execution mode of operation, allowing the user to pre-set a location which will cause an inter

A Accumulator This directive may be used to display and/or alter the contents of the simulated accumulator. A space or comma follow-ing the A will d

5.0 ERROR MESSAGES Most of the errors which can be detected by the simulation program are identified by a single character typeout, followed by rin

return address using the L directive. That may then be pushed down with the S directive, so that the starting address may be loaded into the first sub

the typing of some specializ~d sequences of characters, partial decimal to binary conversion on input, and 6-bit teletype char-acter input with contro

8.0 RAM USAGE The simulation program, to facilitate full usage of the RAM, has organized it into a nominal block of 64 registers, each containing 1